Skid Steer Aux Control Harness 8' 4 Function Deutsch

  
Skid Steer Aux Control Harness - 4 Function. New auxiliary control harness to support 4 solenoids / 2. Pin removal tool (This is to be able to re-pin the skid steer side of the harness if you prefer to use a different control output). Length - 8' Extreme duty cable insulation. Commonly fits most Cat D series, Kubota, Gehl, Mustang, New Holland, Case, JCB/Volvo, Takeuchi, Yanmar & John Deere skid steers with 14 pin connectors. NOTE: Ground wire must be repositioned for John Deere Skid Loaders. Moving a Pin location - Slide the removal tool around the wire and push gently into the connector until it stops. Then pull the wire straight away from the connector and the wire, socket and tool should slide out of the connector.

Check proper installation by gently pulling on the wire. The socket should be locked into place and should not slide out. CT Design Tech - Bringing Back America's Quality!